Subject	Any reason you didn't just cut that all out and weld in
Posted by	BlackholeZ on February 10, 2012 at 7:14 PM
	This message has been viewed 85 times.
In Reply To	New JSWORKS.ORG Build Post - Metalwork Part 1 posted by Jayru on February 10, 2012 at 06:13 PM
Message	either a fabbed up piece or one cut out of a junked Z? That looks like a ton of work. You're a better man than me. Also, I've watched videos of people doing bodywork where they annealed the metal to make it easier to work. Have you looked into doing that? -Dan BlackholeZ VTC Solenoid Caps and Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	New JSWORKS.ORG Build Post - Metalwork Part 1 - Jayru 18:13:38 02/10/12 Any reason you didn't just cut that all out and weld in - BlackholeZ 19:14:48 02/10/12 I've read that annealing doesn't do much for steel - Jayru 19:30:43 02/10/12 I wasn't sure sure how steel behaved either - BlackholeZ 22:16:18 02/10/12 Re: New JSWORKS.ORG Build Post - Metalwork Part 1 - ZwheelZ 20:21:19 02/10/12 Thanks! (n/m) - Jayru 22:30:05 02/10/12 Pretty damn good for a first time repair. (n/m) - Ted (92TT) 23:59:05 02/11/12
Post a Followup	You cannot reply to this message because you are not logged in.