Subject	Warped diagonally. (n/m)
Posted by	sandmanz32 on January 31, 2012 at 5:55 PM
	This message has been viewed 75 times.
In Reply To	Re: Re: Re: Question for the z machinists out there posted by Tech@EPR on January 31, 2012 at 05:44 PM
Message
Follow Ups	Question for the z machinists out there - sandmanz32 13:53:26 01/31/12 Re: Question for the z machinists out there - Tech@EPR 16:51:38 01/31/12 Re: Re: Question for the z machinists out there - sandmanz32 17:24:21 01/31/12 Re: Re: Re: Question for the z machinists out there - Tech@EPR 17:44:54 01/31/12 Warped diagonally. (n/m) - sandmanz32 17:55:30 01/31/12 be sure to check that the cams don't bind - aliaZ 17:06:52 01/31/12
Post a Followup	You cannot reply to this message because you are not logged in.