Subject	Re: Re: Re: Question for the z machinists out there
Posted by	Tech@EPR on January 31, 2012 at 5:44 PM
	This message has been viewed 87 times.
In Reply To	Re: Re: Question for the z machinists out there posted by sandmanz32 on January 31, 2012 at 05:24 PM
Message	corner to corner on the same side as in like the head got hot on one side or corner to corner across diagonally? As mentioned though be sure to take it to a machine shop that can dial indicate it in. I also suggest getting them CBN cut as they produce a superior finish and they typically have a better tolerance in keeping surfaces more true. Facebook = www.facebook.com/epracing
Follow Ups	Question for the z machinists out there - sandmanz32 13:53:26 01/31/12 Re: Question for the z machinists out there - Tech@EPR 16:51:38 01/31/12 Re: Re: Question for the z machinists out there - sandmanz32 17:24:21 01/31/12 Re: Re: Re: Question for the z machinists out there - Tech@EPR 17:44:54 01/31/12 Warped diagonally. (n/m) - sandmanz32 17:55:30 01/31/12 be sure to check that the cams don't bind - aliaZ 17:06:52 01/31/12
Post a Followup	You cannot reply to this message because you are not logged in.