Subject	Question for the z machinists out there
Posted by	sandmanz32 on January 31, 2012 at 1:53 PM
	This message has been viewed 131 times.
Message	I have a set of heads i was planning to reuse on an upcoming project. I disassembled them and checked the surface for warpage. One head is .008" warped. The service spec in the fsm is .004, the absolute limit for block and head millage is .008". My question to you is; can i mill .006" off of these heads and still be safe, and retain close to stock compression? Would i be better off just sourcing new heads? ......And just as they're about to catch me.....Twin......Turbos......Kick.......In!
Follow Ups	Question for the z machinists out there - sandmanz32 13:53:26 01/31/12 Re: Question for the z machinists out there - Tech@EPR 16:51:38 01/31/12 Re: Re: Question for the z machinists out there - sandmanz32 17:24:21 01/31/12 Re: Re: Re: Question for the z machinists out there - Tech@EPR 17:44:54 01/31/12 Warped diagonally. (n/m) - sandmanz32 17:55:30 01/31/12 be sure to check that the cams don't bind - aliaZ 17:06:52 01/31/12
Post a Followup	You cannot reply to this message because you are not logged in.