Subject	rebar and a hammer to break off casting flash
Posted by	aliaZ on January 31, 2012 at 6:48 AM
	This message has been viewed 85 times.
In Reply To	rebar????? (n/m) posted by BlackholeZ on January 30, 2012 at 11:02 PM
Message	use a grinder to clean up what's left
Follow Ups	Cleaning water passage behind water pump - Coldfusown 13:52:44 01/30/12 I believe you are reffering to the passage in the block. - JonnyZ(SoCal) 14:05:08 01/30/12 You are correct. I have already put in my internals - Coldfusown 14:33:44 01/30/12 I did mine post machine shop visit... - SkiFly01 16:11:50 01/30/12 Some rebar and a few bits in a grinder and you can... - SkiFly01 14:32:05 01/30/12 Thank you I will pick up a grinder and rebar to try myself (n/m) - Coldfusown 14:55:03 01/30/12 Anyone have "post surgical" pics? - ZXoltan 16:48:04 01/30/12 should look like this - thumper (Los Angeles) 17:37:35 01/30/12 rebar????? (n/m) - BlackholeZ 23:02:59 01/30/12 rebar and a hammer to break off casting flash - aliaZ 06:48:04 01/31/12 Ah, ok, I was a little scared. (n/m) - BlackholeZ 02:36:40 02/01/12
Post a Followup	You cannot reply to this message because you are not logged in.