Subject	Do the blocks warp that frequently?
Posted by	ZXoltan on January 28, 2012 at 7:10 PM
	This message has been viewed 159 times.
In Reply To	Re: Cometic hg questions.... posted by CmyZ on January 28, 2012 at 05:19 PM
Message	Seems unusual that a cast iron block would need to be milled in most cases. Are there certain circumstances that necessitate this?
Follow Ups	Cometic hg questions.... - Russell.DiVittorio 15:44:45 01/28/12 Yes OEM can handle the power. Do not use copper sealant on - John@Z1 16:07:34 01/28/12 Re: Cometic hg questions.... - CmyZ 17:19:55 01/28/12 *i would have (n/m) - vulcanrush 18:05:09 01/28/12 wgaf. btw, the I should be capitalized. heh. (n/m) - ali300zx 18:44:16 01/28/12 you gaf if you have any self-pride, it's embarrassing - vulcanrush 11:50:04 01/29/12 Trinh Hulk Out = THO (n/m) - ZiNnYc 14:40:19 01/29/12 minor stuff shouldn't warrant corrections imo. - ali300zx 15:43:06 01/29/12 Do the blocks warp that frequently? - ZXoltan 19:10:05 01/28/12 it's not about being warped - FuerGrissa 19:53:51 01/28/12 Re: Cometic hg questions.... - Mickeyzx 17:31:34 01/28/12 Greg Dupree talked me out of using an MLS gasket. OEM is - MixManMash 10:11:06 01/29/12 yep (n/m) - aliaZ 06:55:37 01/31/12 For the size pistons you selected, your OEM HG will be - samsungZ [Houston] 12:22:29 01/29/12
Post a Followup	You cannot reply to this message because you are not logged in.