Subject	depends on cylinder bore finish
Posted by	aliaZ on January 26, 2012 at 11:26 AM
	This message has been viewed 178 times.
In Reply To	Another question for the knowledgeable... posted by Coldfusown on January 26, 2012 at 05:42 AM
Message	with all 6 pistons installed, it will be difficult to spin by hand. What are your bearing clearances? FWIW, I don't use assembly lube on the rings...I use motor oil. Using assembly lube on the rings inhibits ring seating, IMHO.
Follow Ups	So girlfriend out...car parts welcome into dining room :) - Coldfusown 22:54:25 01/25/12 Plenum looks sharp! - Jayru 23:13:10 01/25/12 Plenum looks really good! I like! - BlackholeZ 23:19:26 01/25/12 That is sexy, but I'd never coat the TB surfaces - CoHPhasor 01:38:45 01/26/12 I was thinking about that to. I have some high grit - Coldfusown 01:50:28 01/26/12 If you sand go around the circumference, not - CoHPhasor 02:07:27 01/26/12 have a mapp/propane torch? - BlackholeZ 02:10:09 01/26/12 vht does smell horrible while baking in... - white22sky 19:28:30 01/26/12 Another question for the knowledgeable... - Coldfusown 05:42:50 01/26/12 Was crank measured prior to assembly, mirror polished? - CmyZ 07:42:03 01/26/12 Use more lube... - AHos(Chicago) 09:01:45 01/26/12 depends on cylinder bore finish - aliaZ 11:26:26 01/26/12 Don, what grit finish hone do you recommend - ZXoltan 11:30:39 01/26/12 I'd have to ask my machinist (n/m) - aliaZ 11:53:16 01/26/12 280. - na300zx (OH) 15:29:24 01/26/12 I think in a red car that will look really good. - Boosted1 06:19:09 01/26/12 good point (n/m) - BlackholeZ 14:08:40 01/26/12 NICE! Looks like the finish on mine except mine is - MidLifeZ (DFW) 15:30:41 01/26/12 Looks good, yes my car is Aztec red so I am kinda going with - Coldfusown 16:11:18 01/26/12 Do you know what brand and or shade that plenum is? - PiotrC70 19:04:07 01/26/12 Sorry, dont have that info and it is only barely glossy,not - MidLifeZ (DFW) 06:54:18 01/27/12 Cool. Thanks anyways. (n/m) - PiotrC70 09:21:53 01/27/12
Post a Followup	You cannot reply to this message because you are not logged in.