Subject	do not use the nuts to pull lights into place.
Posted by	Antihero on January 18, 2012 at 2:36 PM
	This message has been viewed 109 times.
In Reply To	Is there anything tricky about replacing the tailights? (n/m) posted by Zblackbeast on January 18, 2012 at 06:59 AM
Message	The studs are friction fit into the plastic housing and if you tighten the nuts to bring the lights in, you will much more likely pull the stud out of the light than pull the light in. adjust your goo and firmly steadily push your lights into place. use the nuts only to hold them in place. Antihero
Follow Ups	Is there anything tricky about replacing the tailights? (n/m) - Zblackbeast 06:59:25 01/18/12 they have a sealent on them and - Halo TTZ 07:23:03 01/18/12 use a heat gun, not a hammer. (n/m) - Adam (NoVA) 07:30:36 01/18/12 ... and easy on the heat. Plastic melts quickly. (n/m) - vorpalZ 08:07:05 01/18/12 Thanks (n/m) - Zblackbeast 09:02:16 01/18/12 There is a small plastic retention tab in the middle of the - MITTZX 09:04:32 01/18/12 Middle section comes out first (no goo). This will allow you - PiotrC70 10:43:08 01/18/12 Instructions - cherryz 10:53:24 01/18/12 Re: Is there anything tricky about replacing the tailights? - doanh 11:38:03 01/18/12 Do not over tighten them, as the extra stress maycausecracks (n/m) - Summeronthechain (MN) 12:00:50 01/18/12 do not use the nuts to pull lights into place. - Antihero 14:36:24 01/18/12
Post a Followup	You cannot reply to this message because you are not logged in.