Subject	Do not over tighten them, as the extra stress maycausecracks (n/m)
Posted by	Summeronthechain (MN) on January 18, 2012 at 12:00 PM
	This message has been viewed 125 times.
In Reply To	Is there anything tricky about replacing the tailights? (n/m) posted by Zblackbeast on January 18, 2012 at 06:59 AM
Message
Follow Ups	Is there anything tricky about replacing the tailights? (n/m) - Zblackbeast 06:59:25 01/18/12 they have a sealent on them and - Halo TTZ 07:23:03 01/18/12 use a heat gun, not a hammer. (n/m) - Adam (NoVA) 07:30:36 01/18/12 ... and easy on the heat. Plastic melts quickly. (n/m) - vorpalZ 08:07:05 01/18/12 Thanks (n/m) - Zblackbeast 09:02:16 01/18/12 There is a small plastic retention tab in the middle of the - MITTZX 09:04:32 01/18/12 Middle section comes out first (no goo). This will allow you - PiotrC70 10:43:08 01/18/12 Instructions - cherryz 10:53:24 01/18/12 Re: Is there anything tricky about replacing the tailights? - doanh 11:38:03 01/18/12 Do not over tighten them, as the extra stress maycausecracks (n/m) - Summeronthechain (MN) 12:00:50 01/18/12 do not use the nuts to pull lights into place. - Antihero 14:36:24 01/18/12
Post a Followup	You cannot reply to this message because you are not logged in.