Subject	Re: Is there anything tricky about replacing the tailights?
Posted by	doanh on January 18, 2012 at 11:38 AM
	This message has been viewed 148 times.
In Reply To	Is there anything tricky about replacing the tailights? (n/m) posted by Zblackbeast on January 18, 2012 at 06:59 AM
Message	you can do it without heat but must have patience. Nissan was not shy about excess use of black sealant.
Follow Ups	Is there anything tricky about replacing the tailights? (n/m) - Zblackbeast 06:59:25 01/18/12 they have a sealent on them and - Halo TTZ 07:23:03 01/18/12 use a heat gun, not a hammer. (n/m) - Adam (NoVA) 07:30:36 01/18/12 ... and easy on the heat. Plastic melts quickly. (n/m) - vorpalZ 08:07:05 01/18/12 Thanks (n/m) - Zblackbeast 09:02:16 01/18/12 There is a small plastic retention tab in the middle of the - MITTZX 09:04:32 01/18/12 Middle section comes out first (no goo). This will allow you - PiotrC70 10:43:08 01/18/12 Instructions - cherryz 10:53:24 01/18/12 Re: Is there anything tricky about replacing the tailights? - doanh 11:38:03 01/18/12 Do not over tighten them, as the extra stress maycausecracks (n/m) - Summeronthechain (MN) 12:00:50 01/18/12 do not use the nuts to pull lights into place. - Antihero 14:36:24 01/18/12
Post a Followup	You cannot reply to this message because you are not logged in.