Subject	Turbine housing removal....PICS
Posted by	ZaXxon on January 14, 2012 at 8:56 AM
	This message has been viewed 729 times.
Message	This is a no brainer....mechanically. I recently searched and couldn't find anything specific to our setup.... so here goes.....enjoy! Tools: - small pick, or screw driver - 1/2" combo wrench (JWT Sport 700 turbos), others may vary Step 1. Remove wastegate actuator keeper, and actuator arm. Step 2. Loosen and remove 6 housing flange bolts. Step 3. Separate housing from CHRA Off to Swain to get coated!
Follow Ups	Turbine housing removal....PICS - ZaXxon 08:56:18 01/14/12 +1 Back from Swain - Ba11erz (MD) 12:36:19 01/14/12 how much was it.. just curious (n/m) - KongZTT GT28RS MD 17:38:40 01/14/12 Re: how much was it? - Ba11erz (MD) 22:17:36 01/14/12 Is that heat reflecting coating inside? (n/m) - BlackholeZ 18:19:08 01/14/12 Re: It's TBC-EX -_- - Ba11erz (MD) 22:09:58 01/14/12 TBC-EX is white lightning - aliaZ 07:50:57 01/15/12 That should be good for about 50 HP (n/m) - phillyz 22:57:50 01/14/12
Post a Followup	You cannot reply to this message because you are not logged in.