TwinTurbo.NET: Nissan 300ZX forum - Its like the water hammer effect from my understanding
People Seeking Info
 
   


     
Subject Its like the water hammer effect from my understanding
     
Posted by Jim (Selin Design) on January 13, 2012 at 1:12 PM
  This message has been viewed 131 times.
     
In Reply To I imagine when an injector opens and creates a miniscule posted by LitlElvis on January 12, 2012 at 11:22 PM
     
Message which can be very damaging to indoor plumbing. It wouldn't matter if there are enough rich injections to balance out the lean injections... the lean injections could still put that individual cylinder at detonation risk. I have no idea of the spread, but say you were running on the edge 12:1 and the spread was +/- 1 you'd be in a bad spot. Conceptually, it seems like a legitimate risk factor we just need to quantify it. Until then, I would err on the side of caution.

www.selindesign.net

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.