Subject	Followup: Used the Hood Latch Cable hole per Evan
Posted by	Gordo 93TT Daytona on January 09, 2012 at 12:36 PM
	This message has been viewed 199 times.
In Reply To	Looking for Bulkhead Access from DS Engine Bay to Console posted by Gordo 93TT Daytona on January 08, 2012 at 10:58 AM
Message	I did pull the wheel and fender liner, but it seemed pretty complicated to get the relatively wide connector through. So like Piotr suggested, I cut the wires; and then taped them to a coathanger wire leader. Having a much smaller cross section to thread through expanded the routing options considerably. I ended up taking the most direct route; which is the grommeted hood release cable. I also used this access port for the nylon hard line for the turbo boost gauge. All three lines passed through using the grommet opening. Thx Guys. Gordo _________________________________________________
Follow Ups	Looking for Bulkhead Access from DS Engine Bay to Console - Gordo 93TT Daytona 10:58:55 01/08/12 I know you probably thought of this, but why not just - PiotrC70 11:22:40 01/08/12 Which loom? The engine harness looks pretty inaccessible - Gordo 93TT Daytona 11:39:37 01/08/12 Sorry. Meant running the wires through and hiding it - PiotrC70 12:25:26 01/08/12 Did you look at/in the fender area? (n/m) - Woody75 (Denver) 12:46:50 01/08/12 That is next if firewall doesn't pan out. Is there specific - Gordo 93TT Daytona 14:23:47 01/08/12 I run mine through the fender and into a groment - toykoz32 15:51:48 01/08/12 Ahh.. I think that is going to be the best bet solution. Thx (n/m) - Gordo 93TT Daytona 16:21:09 01/08/12 No prob. . . . . to get my wires through I just cut a " X " - toykoz32 16:33:10 01/08/12 Just above the CMC or below and to the right. - Evan(CA) 12:04:01 01/08/12 what about the LHD AC drian hole? Its plugged in the photo - toykoz32 12:59:40 01/08/12 Is it seven 0'clock off the steering shaft hole in the pic? - Gordo 93TT Daytona 14:17:06 01/08/12 It comes out to the right between the brake and gas pedal (n/m) - toykoz32 15:28:26 01/08/12 It will work but is close to the down pipes. - Woody75 (Denver) 21:38:20 01/08/12 Followup: Used the Hood Latch Cable hole per Evan - Gordo 93TT Daytona 12:36:14 01/09/12
Post a Followup	You cannot reply to this message because you are not logged in.