TwinTurbo.NET: Nissan 300ZX forum - Just above the CMC or below and to the right.
Subject
Just above the CMC or below and to the right.
Posted by
Evan(CA)
on January 08, 2012 at 12:04 PM
This message has been viewed
317
times.
In Reply To
Looking for Bulkhead Access from DS Engine Bay to Console
posted by Gordo 93TT Daytona
on January 08, 2012 at 10:58 AM
Message
Follow Ups
Looking for Bulkhead Access from DS Engine Bay to Console
-
Gordo 93TT Daytona
10:58:55 01/08/12
I know you probably thought of this, but why not just
-
PiotrC70
11:22:40 01/08/12
Which loom? The engine harness looks pretty inaccessible
-
Gordo 93TT Daytona
11:39:37 01/08/12
Sorry. Meant running the wires through and hiding it
-
PiotrC70
12:25:26 01/08/12
Did you look at/in the fender area? (n/m)
-
Woody75 (Denver)
12:46:50 01/08/12
That is next if firewall doesn't pan out. Is there specific
-
Gordo 93TT Daytona
14:23:47 01/08/12
I run mine through the fender and into a groment
-
toykoz32
15:51:48 01/08/12
Ahh.. I think that is going to be the best bet solution. Thx (n/m)
-
Gordo 93TT Daytona
16:21:09 01/08/12
No prob. . . . . to get my wires through I just cut a " X "
-
toykoz32
16:33:10 01/08/12
Just above the CMC or below and to the right. -
Evan(CA)
12:04:01 01/08/12
what about the LHD AC drian hole? Its plugged in the photo
-
toykoz32
12:59:40 01/08/12
Is it seven 0'clock off the steering shaft hole in the pic?
-
Gordo 93TT Daytona
14:17:06 01/08/12
It comes out to the right between the brake and gas pedal (n/m)
-
toykoz32
15:28:26 01/08/12
It will work but is close to the down pipes.
-
Woody75 (Denver)
21:38:20 01/08/12
Followup: Used the Hood Latch Cable hole per Evan
-
Gordo 93TT Daytona
12:36:14 01/09/12
Post a
Followup
You cannot reply to this message because you are not
logged in
.