TwinTurbo.NET: Nissan 300ZX forum - If I were to put one in the bay, it would be liquid filled.
People Seeking Info
 
   


     
Subject If I were to put one in the bay, it would be liquid filled.
     
Posted by ZiNnYc on December 14, 2011 at 7:08 PM
  This message has been viewed 245 times.
     
In Reply To Where else would you install a mechanical fuel press. gauge? (n/m) posted by Bernie (NoVA) on December 14, 2011 at 02:29 PM
     
Message Dry ones that I've seen don't last very long and simply aren't reliable after taking a beating from the motor. The whole point of a gauge is to read pressures reliably.

I would say install an NPT plug and only use the dry gauge when required.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.