Subject	Where else would you install a mechanical fuel press. gauge? (n/m)
Posted by	Bernie (NoVA) on December 14, 2011 at 2:29 PM
	This message has been viewed 182 times.
In Reply To	Hmm...hope it lasts in the bay. nice work on the plumbing. (n/m) posted by ZiNnYc on December 14, 2011 at 05:22 AM
Message
Follow Ups	Fuel Pressure Gauge for Engine Bay & Interior Sender Unit - Gordo 93TT Daytona 00:54:17 12/13/11 I like the instal. Very nice (n/m) - BCs300z 03:12:21 12/13/11 using any thread sealant? (n/m) - eazyez 04:30:38 12/13/11 Permatex High Temp Thread Sealant. - Gordo 93TT Daytona 13:20:11 12/13/11 VERY Clean install!! - TReedsZ 04:48:13 12/13/11 Nice! (n/m) - ChaseGrayTT 06:09:18 12/13/11 Good idea on the setup. I'd be sure all those fasteners - Boosted1 06:21:02 12/13/11 Nice work. (n/m) - my91z 06:22:57 12/13/11 Very Nice Work (n/m) - Zski 07:04:24 12/13/11 Not bad for an old timer. (n/m) - Bernie (NoVA) 07:35:08 12/13/11 good work (n/m) - RobZ32 10:50:29 12/13/11 No -AN, No care - FuerGrissa 16:13:43 12/13/11 did you remove the hood warning light from the cluster? (n/m) - Atl300zxTT 16:56:13 12/13/11 No. The switch was removed and the connector taped up. - Gordo 93TT Daytona 17:36:54 12/13/11 Is that gauge shockproof? (n/m) - ZiNnYc 21:44:06 12/13/11 The needle does not bounce.. even when the gauge is tapped. - Gordo 93TT Daytona 23:05:34 12/13/11 Hmm...hope it lasts in the bay. nice work on the plumbing. (n/m) - ZiNnYc 05:22:13 12/14/11 What do you mean? There's nothing unusual about this gauge - Gordo 93TT Daytona 07:24:50 12/14/11 Where else would you install a mechanical fuel press. gauge? (n/m) - Bernie (NoVA) 14:29:37 12/14/11 In the interior, pu$$y :) Y u no like Z BBQ? (n/m) - BigTDogg (MA) 14:36:31 12/14/11 If I were to put one in the bay, it would be liquid filled. - ZiNnYc 19:08:25 12/14/11 Very nice indeed! (n/m) - OverZealous (CT) 22:14:06 12/13/11
Post a Followup	You cannot reply to this message because you are not logged in.