TwinTurbo.NET: Nissan 300ZX forum - Nick sent me these pictures when I bought mine back in May.
Subject
Nick sent me these pictures when I bought mine back in May.
Posted by
Wright (Ca)
on December 12, 2011 at 5:01 PM
This message has been viewed
505
times.
In Reply To
Question on breather mods installation....
posted by RonZ300 (Socal)
on December 12, 2011 at 02:25 PM
Message
It will probably vary a bit depending on what manifolds and turbos you have though.
Follow Ups
Question on breather mods installation....
-
RonZ300 (Socal)
14:25:18 12/12/11
You don't need to pull the motor for the inlet piping. Some
-
HighPsi (NorCal)
15:04:01 12/12/11
stock motor mount grinding?
-
timmaz
15:18:58 12/12/11
...
-
HighPsi (NorCal)
15:51:18 12/12/11
From a few days ago...
-
Wright (Ca)
15:16:10 12/12/11
I ground down my motor mounts then just went with
-
Xteam300TT (South Tx )
16:18:22 12/12/11
thanks guys! Drivers side only or both sides req grinding? (n/m)
-
timmaz
16:25:20 12/12/11
I dont remember , half way through I decided on BDE . (n/m)
-
Xteam300TT (South Tx )
16:54:59 12/12/11
what are those isolators on your stock mounts? (n/m)
-
LitlElvis
13:19:44 12/13/11
Nick sent me these pictures when I bought mine back in May. -
Wright (Ca)
17:01:13 12/12/11
Post a
Followup
You cannot reply to this message because you are not
logged in
.