Subject	stock motor mount grinding?
Posted by	timmaz on December 12, 2011 at 3:18 PM
	This message has been viewed 450 times.
In Reply To	You don't need to pull the motor for the inlet piping. Some posted by HighPsi (NorCal) on December 12, 2011 at 03:04 PM
Message	I just ordered Ash 2.5 inlet piping V1 for stock turbos. I have the stock pipes off. You wouldnt happen to have a picture or be able to guide me to a picture of the required grinding?
Follow Ups	Question on breather mods installation.... - RonZ300 (Socal) 14:25:18 12/12/11 You don't need to pull the motor for the inlet piping. Some - HighPsi (NorCal) 15:04:01 12/12/11 stock motor mount grinding? - timmaz 15:18:58 12/12/11 ... - HighPsi (NorCal) 15:51:18 12/12/11 From a few days ago... - Wright (Ca) 15:16:10 12/12/11 I ground down my motor mounts then just went with - Xteam300TT (South Tx ) 16:18:22 12/12/11 thanks guys! Drivers side only or both sides req grinding? (n/m) - timmaz 16:25:20 12/12/11 I dont remember , half way through I decided on BDE . (n/m) - Xteam300TT (South Tx ) 16:54:59 12/12/11 what are those isolators on your stock mounts? (n/m) - LitlElvis 13:19:44 12/13/11 Nick sent me these pictures when I bought mine back in May. - Wright (Ca) 17:01:13 12/12/11
Post a Followup	You cannot reply to this message because you are not logged in.