Subject	You don't need to pull the motor for the inlet piping. Some
Posted by	HighPsi (NorCal) on December 12, 2011 at 3:04 PM
	This message has been viewed 294 times.
In Reply To	Question on breather mods installation.... posted by RonZ300 (Socal) on December 12, 2011 at 02:25 PM
Message	Grinding is nessacary if you have stock motor mounts. The plenum has to be pulled for the 58mm throttle bodies.
Follow Ups	Question on breather mods installation.... - RonZ300 (Socal) 14:25:18 12/12/11 You don't need to pull the motor for the inlet piping. Some - HighPsi (NorCal) 15:04:01 12/12/11 stock motor mount grinding? - timmaz 15:18:58 12/12/11 ... - HighPsi (NorCal) 15:51:18 12/12/11 From a few days ago... - Wright (Ca) 15:16:10 12/12/11 I ground down my motor mounts then just went with - Xteam300TT (South Tx ) 16:18:22 12/12/11 thanks guys! Drivers side only or both sides req grinding? (n/m) - timmaz 16:25:20 12/12/11 I dont remember , half way through I decided on BDE . (n/m) - Xteam300TT (South Tx ) 16:54:59 12/12/11 what are those isolators on your stock mounts? (n/m) - LitlElvis 13:19:44 12/13/11 Nick sent me these pictures when I bought mine back in May. - Wright (Ca) 17:01:13 12/12/11
Post a Followup	You cannot reply to this message because you are not logged in.