Subject	Question on breather mods installation....
Posted by	RonZ300 (Socal) on December 12, 2011 at 2:25 PM
	This message has been viewed 368 times.
Message	Can the ASHSPEC 2.5" turbo inlet pipe kit be installed without pulling the engine and if so, does the plenum need to be pulled? I know the ASHSPEC 2.5" turbo outlet pipe kit can be installed without pulling the engine but does it require a plenum pull? Thanks in advance!
Follow Ups	Question on breather mods installation.... - RonZ300 (Socal) 14:25:18 12/12/11 You don't need to pull the motor for the inlet piping. Some - HighPsi (NorCal) 15:04:01 12/12/11 stock motor mount grinding? - timmaz 15:18:58 12/12/11 ... - HighPsi (NorCal) 15:51:18 12/12/11 From a few days ago... - Wright (Ca) 15:16:10 12/12/11 I ground down my motor mounts then just went with - Xteam300TT (South Tx ) 16:18:22 12/12/11 thanks guys! Drivers side only or both sides req grinding? (n/m) - timmaz 16:25:20 12/12/11 I dont remember , half way through I decided on BDE . (n/m) - Xteam300TT (South Tx ) 16:54:59 12/12/11 what are those isolators on your stock mounts? (n/m) - LitlElvis 13:19:44 12/13/11 Nick sent me these pictures when I bought mine back in May. - Wright (Ca) 17:01:13 12/12/11
Post a Followup	You cannot reply to this message because you are not logged in.