| Availability? About a month, please don't hold me to that. I'll get them to market ASAP but I won't rush them, they have to be right. Pricing? Nothing firmed up yet. I'm shooting between $400-500 for the set. Obviously the lower the better for everyone (more people will buy) but there's a lot to take into consideration. The first few sets will not be good for me (design/setup/fixtures/programming) but I am OK with this. You have to spend money to make money. Modifications? The plenum will need to be opened up to 63mm (I've already done this, there is plenty of material remaining). You will need to swap your throttle linkages/springs (these would be a tremendous cost to supply). The lower inner bolt (closest to timing covers) most likely will be shrouded by the TB barrel and only accessible with the plenum off the engine, I'm working on a solution for this. The timing belt covers may interfere with the clamp, need to look at this. Stanza TBs fit so mine should as well. I'm thinking a 2.5" to 2.75" coupler will be needed from IC piping to TB. This needs to be checked for clearance with the timing belt covers.
I will post more as things materialize.
Thank you
Rob
![]() SRC="http://ttp://i31.photobucket.com/albums/c359/RobZ90TT/AZR%201
0/beyondsig.jpg"> |
