Subject	I might not say amateur mechanic,
Posted by	BlackholeZ on December 01, 2011 at 2:34 AM
	This message has been viewed 255 times.
In Reply To	No posted by CoHPhasor on November 30, 2011 at 09:49 PM
Message	but go look at torque wrenches by Snap on and Mac. easily twice that. I've worked in shops that didn't allow Craftsman torque wrenches on the premises. -Dan BlackholeZ VTC Solenoid Caps and Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Should I trust this torque wrench? - z-u-later 21:56:27 11/28/11 I wouldn't use it to torque anything I wanted - zICEman(East TN) 22:10:38 11/28/11 That all depends. Trusting it right out of the box may be - CoHPhasor 22:39:30 11/28/11 A friend Calibrates tools - toykoz32 02:06:37 11/29/11 ^ See? calibration => Name on the box - CoHPhasor 03:01:16 11/29/11 Yep,"The bitterness of poor quality remains - samsungZ (Houston) 06:56:17 11/29/11 I recommend the CDI torque wrenches from Snap On. - Mike aka thedeadking (NoVA) 08:43:45 11/29/11 I've never had an issue with them. (n/m) - Woody75 (Denver) 09:46:15 11/29/11 I have a HF 3/8. Seems fine. The FSM sometimes gives a - evan_aggie(ATX) 10:49:59 11/29/11 I love my Matco TRC250FA. 25-250 lbs. torque range. - zICEman(East TN) 10:58:58 11/29/11 hf - mcdj300z 20:33:22 11/29/11 Re: Should I trust this torque wrench? - VeganCannibal 11:47:04 11/30/11 No - CoHPhasor 21:49:18 11/30/11 I might not say amateur mechanic, - BlackholeZ 02:34:04 12/01/11 Hell - I don't allow Craftsman torque wrenches :-) - Bernie (NoVA) 10:32:55 12/01/11
Post a Followup	You cannot reply to this message because you are not logged in.