Subject	Yeah, after closer inspection
Posted by	Rob'Z on November 23, 2011 at 6:13 PM
	This message has been viewed 137 times.
In Reply To	I am not sure 65 will fit. posted by ConVerTT on November 22, 2011 at 08:34 PM
Message	63mm is probably the max due to the bolts. I'll have to double check the timing covers but people wanting these huge TBs may have to make modifications or run w/o the covers. 63mm bore with a .062" thick throttle plate along with a milled throttle shaft should still outflow the ID of the 2.5" IC piping which is around 60mm. Rob SRC="http://ttp://i31.photobucket.com/albums/c359/RobZ90TT/AZR%201 0/beyondsig.jpg">
Follow Ups	Flow bench results from 54mm TB vs stock - Rob'Z 18:00:59 11/22/11 I'm ready for the 65's :) (n/m) - jlag 18:44:57 11/22/11 So 54mm outflows the Massives? - madscientist222 18:55:54 11/22/11 Negative - MrOzzie5183 19:16:11 11/22/11 The In/Outs may be bigger but they still flow through - madscientist222 19:56:15 11/22/11 If you can make it a little bigger, I'm game... - SimaYi 20:45:00 11/22/11 You need to consider the pressure drop that they were flowed - black300zx 19:45:26 11/22/11 Arent you confusing pressure drop with flow pressure? - madscientist222 19:51:00 11/22/11 I didn't choose the number - Rob'Z 21:06:42 11/22/11 Sounds like a case of mistaken units... - Jim (Selin Design) 23:37:21 11/22/11 Re: Mistaken units? Rob'Z in in/hg, ahs's in in/H2O? - Obeeone 09:26:08 11/23/11 How so? - Jim (Selin Design) 10:57:27 11/23/11 You are correct Jim - Rob'Z 20:15:19 11/23/11 Thinking of bottlenecking in this way is misleading... - Jim (Selin Design) 23:49:47 11/22/11 And the current is tested in a 1 volt circuit - not4resaleZ 10:07:49 11/23/11 Great job , those numbers are nice . Now if you can get - Xteam300TT (South Tx ) 19:13:55 11/22/11 They seal like OEM - Rob'Z 21:05:21 11/22/11 I am not sure 65 will fit. - ConVerTT 20:34:49 11/22/11 Yeah, after closer inspection - Rob'Z 18:13:39 11/23/11 Nice work Rob! (n/m) - Piranha 21:12:51 11/22/11 Nice! (n/m) - BoneZ (MD) 22:13:20 11/22/11 What's the residual thickness of the tube wall? - ZXoltan 04:44:10 11/23/11 The wall should be fine, it's as thick as the IC piping - Rob'Z 18:11:11 11/23/11
Post a Followup	You cannot reply to this message because you are not logged in.