Subject	I am not sure 65 will fit.
Posted by	ConVerTT on November 22, 2011 at 8:34 PM
	This message has been viewed 161 times.
In Reply To	Flow bench results from 54mm TB vs stock posted by Rob'Z on November 22, 2011 at 06:00 PM
Message	I have a set of 60 mm TB's. I slotted the existing TB holes so that I could install them using the existing holes in the plenum, and so the centerline of the TBs would be in the correct plane. Long story short, when installed the heads of the bolts are snug against the barrel of the 60 mm TBs. Also, there is not a lot of room between the coupler and the timing belt cover (probably a mm or less). Appreciate you hard work - just a heads up.
Follow Ups	Flow bench results from 54mm TB vs stock - Rob'Z 18:00:59 11/22/11 I'm ready for the 65's :) (n/m) - jlag 18:44:57 11/22/11 So 54mm outflows the Massives? - madscientist222 18:55:54 11/22/11 Negative - MrOzzie5183 19:16:11 11/22/11 The In/Outs may be bigger but they still flow through - madscientist222 19:56:15 11/22/11 If you can make it a little bigger, I'm game... - SimaYi 20:45:00 11/22/11 You need to consider the pressure drop that they were flowed - black300zx 19:45:26 11/22/11 Arent you confusing pressure drop with flow pressure? - madscientist222 19:51:00 11/22/11 I didn't choose the number - Rob'Z 21:06:42 11/22/11 Sounds like a case of mistaken units... - Jim (Selin Design) 23:37:21 11/22/11 Re: Mistaken units? Rob'Z in in/hg, ahs's in in/H2O? - Obeeone 09:26:08 11/23/11 How so? - Jim (Selin Design) 10:57:27 11/23/11 You are correct Jim - Rob'Z 20:15:19 11/23/11 Thinking of bottlenecking in this way is misleading... - Jim (Selin Design) 23:49:47 11/22/11 And the current is tested in a 1 volt circuit - not4resaleZ 10:07:49 11/23/11 Great job , those numbers are nice . Now if you can get - Xteam300TT (South Tx ) 19:13:55 11/22/11 They seal like OEM - Rob'Z 21:05:21 11/22/11 I am not sure 65 will fit. - ConVerTT 20:34:49 11/22/11 Yeah, after closer inspection - Rob'Z 18:13:39 11/23/11 Nice work Rob! (n/m) - Piranha 21:12:51 11/22/11 Nice! (n/m) - BoneZ (MD) 22:13:20 11/22/11 What's the residual thickness of the tube wall? - ZXoltan 04:44:10 11/23/11 The wall should be fine, it's as thick as the IC piping - Rob'Z 18:11:11 11/23/11
Post a Followup	You cannot reply to this message because you are not logged in.