Subject	More than likely a rod bearing
Posted by	ZXoltan on November 22, 2011 at 6:55 AM
	This message has been viewed 99 times.
In Reply To	deal or no deal posted by Nis300owner on November 22, 2011 at 02:16 AM
Message	If its spun, then you're most likely looking at a rebuild with a replacement crank and at least that rod replaced or resized (minimum). If you're just doing it to take it apart and not for actual use and you can get it CHEAP, then go for it.
Follow Ups	deal or no deal - Nis300owner 02:16:52 11/22/11 Re: deal or no deal - lurker_nz 02:34:02 11/22/11 More than likely a rod bearing - ZXoltan 06:55:29 11/22/11
Post a Followup	You cannot reply to this message because you are not logged in.