TwinTurbo.NET: Nissan 300ZX forum - I had the 1pc rotors "kit" on my TT and yes, there was a dif
People Seeking Info
 
   


     
Subject I had the 1pc rotors "kit" on my TT and yes, there was a dif
     
Posted by PiotrC70 on November 22, 2011 at 1:57 AM
  This message has been viewed 215 times.
     
In Reply To Anyone running this Z1 BBK? posted by Jayru on November 21, 2011 at 07:40 PM
     
Message over stock setup. I also had stainless lines and the BMC brace. Would I do the kit again... No. It annoys the piss out of me that there is ~1/2 to 3/4" of wasted rotor on the inside, and if I recall correctly, there isn't 100% pad contact. The 2 piece rotor option is way better and is ob obviously lighter. Probably the best option if you want an improvement over stock and yet still remaining cost effective.
You can look into the SRT-8 brembo upgrade in the classifieds, but again, 14" rotor that is 1pc will suck, even if the calipers look good.
Good Luck.

1993 TT. R.I.P. 09.15.2010

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.