Subject	IDK but under normal city driving in summer
Posted by	Gennosuke on November 18, 2011 at 7:29 PM
	This message has been viewed 117 times.
In Reply To	what is the optimum operating temperature? (n/m) posted by fuzzymonkey on November 18, 2011 at 06:14 PM
Message	my aftermarket water temp gauge always says I'm at 175. (I'm always between 160-180). Except one time when I was driving at 100mph for like 2hrs straight on the freeway it stayed at 200-205
Follow Ups	Reasons NOT to get an overdrive pulley? - ZiNnYc 17:15:56 11/18/11 There is an underdrive crank pulley on the motor in question (n/m) - ZiNnYc 17:23:18 11/18/11 Re: Reasons NOT to get an overdrive pulley? - SimaYi 17:25:43 11/18/11 The thermostat sets a minimum engine operating temp. - zellamay 17:29:13 11/18/11 Faulty Tstat or coolant temp sensor. I had a UR, HOWE - PiotrC70 17:49:42 11/18/11 ditto. (n/m) - Halo TTZ 19:10:00 11/18/11 2nd (n/m) - HighPsi (NorCal) 01:54:49 11/20/11 what is the optimum operating temperature? (n/m) - fuzzymonkey 18:14:41 11/18/11 IDK but under normal city driving in summer - Gennosuke 19:29:10 11/18/11 Hmm... - madscientist222 18:24:26 11/18/11 so then the stock pulleys would make the "water circulate - Halo TTZ 19:12:49 11/18/11 Did you say 62-70 degrees? Don't make no sense - RevTech 19:31:15 11/18/11 Probably means centigrade (n/m) - dogpile 19:35:53 11/18/11 What is centigrade? (n/m) - new2boost 19:50:23 11/18/11 Celsuis. I think he left off the 1XX in the front (n/m) - BigTDogg (MA) 20:05:03 11/18/11 Dont think he left off a 1 in - new2boost 20:36:29 11/18/11 I think he meant to type 162-170F (n/m) - BigTDogg (MA) 20:47:07 11/18/11 Isnt that standard operating temp or close? (n/m) - new2boost 21:35:04 11/18/11 should be between 190-210 degrees (n/m) - LiftedCracker 21:41:04 11/18/11 70C is 158F. which is too cold - dogpile 00:09:54 11/19/11 From the US...North Carolina I believe. (n/m) - ZiNnYc 15:59:03 11/19/11 HA... - 90GoldZ 21:58:26 11/18/11 Free business plugs though (n/m) - Wright (Ca) 22:48:49 11/18/11 Stock ecu ends and timing and fuel trim at 178 f - ztunerz 22:41:16 11/18/11 Where are you getting your info from? (n/m) - Joe@ZSpeedperformance 23:00:22 11/18/11 He wisely deleted the post, but it was from the second link - BigTDogg (MA) 16:56:39 11/19/11 This post is just silly. (n/m) - John (MD) 14:38:10 11/19/11
Post a Followup	You cannot reply to this message because you are not logged in.