Subject	I did measure runout witn and indicator dial.
Posted by	JMartz on November 04, 2011 at 8:31 AM
	This message has been viewed 75 times.
In Reply To	Did you measure run out of the rotors when you posted by Joe@ZSpeedperformance on November 03, 2011 at 07:56 PM
Message	The rotor had about .002 inches of runout. I have done brakes many times in many cars. This is only one that I failed at.
Follow Ups	Brake vibration update, new pads report... - JMartz 15:01:40 11/03/11 Where can we find more info about the z1 upper control arms? (n/m) - Wright (Ca) 15:16:34 11/03/11 Call them. I am local so I get to visit the store - JMartz 08:27:11 11/04/11 That sounds interesting. I recently helped install some - Wright (Ca) 11:17:27 11/04/11 The units are in their final stages if testing - JMartz 11:30:46 11/04/11 after 8 years, you'll need to get the rotors turned - vorpalZ 15:56:04 11/03/11 i agree,you most likely have uneven deposits on your rotors, - sawbonez 16:09:21 11/03/11 I have to get that done. The local "performance car" - JMartz 08:33:42 11/04/11 i have just used hawk blue pads, just keep the temps - sawbonez 21:10:13 11/04/11 Forgot to mention that the total milage in those 8 - JMartz 08:29:00 11/04/11 Did you measure run out of the rotors when you - Joe@ZSpeedperformance 19:56:45 11/03/11 I did measure runout witn and indicator dial. - JMartz 08:31:13 11/04/11
Post a Followup	You cannot reply to this message because you are not logged in.