TwinTurbo.NET: Nissan 300ZX forum - I installed the same setup as evanaggie.
Subject
I installed the same setup as evanaggie.
Posted by
1911a1
on October 28, 2011 at 10:00 PM
This message has been viewed
87
times.
In Reply To
You can mount the overflow tank anywhere, doesn't have
posted by zellamay
on October 28, 2011 at 09:36 PM
Message
same bottle from summit, almost the same angle. I drilled 2 small pilot holes and used self-tapping screws for the bottle clamp.
Follow Ups
What are members with larger smic's doing to fix this ?
-
Xteam300TT (South Tx )
16:07:31 10/28/11
Re: What are members with larger smic's doing to fix this ?
-
Stadsport (PHX)
16:17:39 10/28/11
I dont think you should be going through a quart of overflow (n/m)
-
ZiNnYc
16:21:58 10/28/11
1st of all, good move.
-
ZiNnYc
16:19:41 10/28/11
Thanx , any pics available in the various locations ? (n/m)
-
Xteam300TT (South Tx )
16:28:42 10/28/11
Someone else might be able to help you out with pics
-
ZiNnYc
16:33:31 10/28/11
I can post a pic later of my plastic tank. Just installed. (n/m)
-
evan_aggie(ATX)
16:38:45 10/28/11
great , thanx ! (n/m)
-
Xteam300TT (South Tx )
16:49:38 10/28/11
I may decide to move it, but for now, here is what I planned
-
evan_aggie(ATX)
18:53:42 10/28/11
^^^^^This is the correct lacation and most sensible
-
TTZEDHEAD
22:55:26 10/28/11
That location obstructs the IC pipe routing. (n/m)
-
Bernie (NoVA)
11:55:23 10/29/11
How do you plan on connecting the intercooler
-
Sly
07:22:59 10/29/11
moroso overflow tank
-
timmaz
18:21:13 10/28/11
That's kind of cool... would you do it again? (n/m)
-
thumper
21:21:46 10/28/11
Exactly my setup and location (n/m)
-
HighPsi (NorCal)
20:57:05 10/29/11
You don't really have to do anything about it...
-
Bernie (NoVA)
21:07:38 10/28/11
2nd (n/m)
-
Woody75 (Denver)
17:55:56 10/29/11
yup, deleted CC, removed hard lines, Massives fit fine
-
vorpalZ
22:52:13 10/29/11
You can mount the overflow tank anywhere, doesn't have
-
zellamay
21:36:39 10/28/11
I installed the same setup as evanaggie. -
1911a1
22:00:27 10/28/11
I used some expanded stainless.
-
MPV TT
23:32:41 10/28/11
Post a
Followup
You cannot reply to this message because you are not
logged in
.