Subject	I don't recommend it
Posted by	aliaZ on October 19, 2011 at 1:08 PM
	This message has been viewed 120 times.
In Reply To	what do you thinking of 89mm pistions posted by kourt11412 on October 19, 2011 at 10:11 AM
Message	The best bet is to go the minimum oversize to clean up the bores
Follow Ups	what do you thinking of 89mm pistions - kourt11412 10:11:02 10/19/11 what do you think of 89mm pistions (n/m) - kourt11412 10:26:44 10/19/11 I think they are 1.5mm larger in diameter - Rob'Z 12:26:41 10/19/11 It's been done before - MrOzzie5183 12:47:40 10/19/11 I don't recommend it - aliaZ 13:08:05 10/19/11 ^^^ This. (n/m) - MixManMash 13:10:45 10/19/11 The message posted by samsungz (Houston) on 13:16:52 10/19/11 was removed by the members on 09:13:23 10/20/11 NO (n/m) - ztunerz 11:09:47 10/20/11 Re: what do you thinking of 89mm pistions - -Siggi- 16:23:04 10/20/11 if you were losing ring seal due to bore flex - aliaZ 17:58:35 10/20/11 Re: if you were losing ring seal due to bore flex - BLACK Z 03:51:43 10/21/11 yes, it can be safely done - aliaZ 07:44:17 10/21/11 Re: yes, it can be safely done - BLACK Z 08:22:50 10/21/11
Post a Followup	You cannot reply to this message because you are not logged in.