Subject	I disagree. If you have 3in expansion DPs, you do. I can't
Posted by	evan_aggie(ATX) on October 18, 2011 at 4:33 PM
	This message has been viewed 173 times.
In Reply To	You don't need to disconnect U-joint even with DPs installed posted by KongZTT GT28RS MD on October 18, 2011 at 03:52 PM
Message	answer for non expansion downpipes. So, either you've pulled/installed many engines without expansion downpipes, or you've got a trick that isn't obvious. You can see from the photos below (taken such that you can see where the DPs would fall) that there is clearly overlap from the downpipes that would hit the steering u-joint. There was no room to move the engine forward at all with the AC condenser installed.
Follow Ups	NA2TT Update - Engine In & DPs Wrapped - evan_aggie(ATX) 08:10:13 10/18/11 I was able to install it without touching the u-joint. - BigTDogg (MA) 12:48:12 10/18/11 I searched. That is only your opinion regarding DPs... - evan_aggie(ATX) 14:10:17 10/18/11 Yep, my opinion. My opinion called the laws o thermodynamics (n/m) - BigTDogg (MA) 16:11:30 10/18/11 In general you want to keep heat in the system BEFORE the - ConVerTT 18:17:57 10/18/11 You don't need to disconnect U-joint even with DPs installed - KongZTT GT28RS MD 15:52:30 10/18/11 I disagree. If you have 3in expansion DPs, you do. I can't - evan_aggie(ATX) 16:33:08 10/18/11 These were with 3" super splits.. - KongZTT GT28RS MD 19:13:42 10/18/11 Also..the car here has GT28R turbos (n/m) - KongZTT GT28RS MD 19:14:50 10/18/11 Same here, been pulling/installing engines for 7+ yrs.. - Kandy Orange Z 17:30:24 10/18/11 Driver side had to be removed in my case - Drk93TT 19:51:31 10/18/11 Depends. - MixManMash 18:28:16 10/18/11 In my case, 530bb + 3in exp = u-joint needs to be removed. - evan_aggie(ATX) 20:49:30 10/18/11
Post a Followup	You cannot reply to this message because you are not logged in.