Subject	Re: huh?? Bernie just told you what your problem is....
Posted by	Jiro on October 15, 2011 at 3:32 AM
	This message has been viewed 62 times.
In Reply To	huh?? Bernie just told you what your problem is.... posted by LJZTT on October 14, 2011 at 12:34 PM
Message	Problem solved. The U-joint connected to the R200 rear end of the NA was siezed up. I suppose it was getting a little rusty. Replaced that propellor shaft and it was perfect. This explains also why the previous owner of this Z blew up 3 auto transmission. Special thanks to Dan and Dustin at the Z shop in Surrey in helping me figure it out.
Follow Ups	Hybrid driveshaft doesn't seem to work 100% so far... - Jiro 11:32:55 10/14/11 The stock 2 piece driveshafts are balanced as a unit. - Bernie (NoVA) 12:15:39 10/14/11 Re: Hybrid driveshaft doesn't seem to work 100% so far... - Jiro 12:28:56 10/14/11 huh?? Bernie just told you what your problem is.... - LJZTT 12:34:28 10/14/11 Re: huh?? Bernie just told you what your problem is.... - Jiro 03:32:46 10/15/11 You're welcome. (n/m) - Bernie (NoVA) 09:13:37 10/17/11
Post a Followup	You cannot reply to this message because you are not logged in.