Subject	I have the Ash IBC..
Posted by	ForceFedTT (SoCal) on October 14, 2011 at 4:08 PM
	This message has been viewed 169 times.
In Reply To	Anybody have a Ashspec ECU with integrated BOOST Controller? posted by 95BlackSMZ on October 14, 2011 at 03:05 PM
Message	You have to have the boost jets (supplied by Ash) installed to reach boost levels beyond where your wastegate actautors are set. I.e., if your actuators are set at 12psi and u didn't install the jets, you'll never get past 12psi. Sounds like you may have something else going one. Why do you have the EBC -AND- the the IBC?? Redundant, don't you think? That may also be causing your problem.
Follow Ups	Anybody have a Ashspec ECU with integrated BOOST Controller? - 95BlackSMZ 15:05:32 10/14/11 Send him an email... He usually responds pretty quick! (n/m) - JonnyZ(SoCal) 15:12:18 10/14/11 Why are you running two boost controllers anyway? (n/m) - ZXoltan 15:17:38 10/14/11 Re: Why are you running two boost controllers anyway? - 95BlackSMZ 15:20:16 10/14/11 If your profile is current..... - TTZ2NV(TX) 11:12:02 10/15/11 If you have a properly installed evc I doubt the ash spec - Wright (Ca) 15:19:17 10/14/11 Re: If you have a properly installed evc I doubt the ash spec - 95BlackSMZ 15:22:40 10/14/11 "a two stage Ashspec ECU for race/pump gas with the - dogpile 15:29:18 10/14/11 Re: "a two stage Ashspec ECU for race/pump gas with the - 95BlackSMZ 15:58:56 10/14/11 What is the boost with the BC off? - dogpile 16:09:15 10/14/11 I have the Ash IBC.. - ForceFedTT (SoCal) 16:08:56 10/14/11 ECU cannot control the boost without stock boost solenoids (n/m) - RevTech 11:36:49 10/15/11
Post a Followup	You cannot reply to this message because you are not logged in.