TwinTurbo.NET: Nissan 300ZX forum - What would it all prove... that a crappy weld breaks under
People Seeking Info
 
   


     
Subject What would it all prove... that a crappy weld breaks under
     
Posted by LitlElvis on October 01, 2011 at 12:15 PM
  This message has been viewed 988 times.
     
In Reply To I would like to see these results. (n/m) posted by rojoloco (San Diego) on October 01, 2011 at 11:45 AM
     
Message less load than a proper weld? That's a given.

How many ways are there to prove the welds are junk? I mean, should I have them x-rayed, sonic tested, perform a metallurgical spectrographic analysis or put them in a trash compactor to see how, when, where they break?

Does every possible test need to be performed to prove they are low quality and inferior?

I'm pretty much done wasting my money and time on these - let the pictures speak a thousand words.

I'm not harping on you, but further analysis is a moot point.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.