Subject	Re: Pic/ info request
Posted by	ouikikazz on October 01, 2011 at 8:46 AM
	This message has been viewed 90 times.
In Reply To	Pic/ info request posted by Nis300owner on October 01, 2011 at 02:23 AM
Message	IIRC, there is no grinding when using a na trans on a tt flywheel...its only when u need to use a tt trans on a na flywheel the grinding is done to make the starter sit closer to the na flywheel...in which case i highly recommend to just buy a tt flywheel because the grinding is ridiculously complicated and if u mess it up, it wont work and ruins your trans (i know i've tried) so in essence na trans w/tt flywheel = ok which purchaser shim...other than that just buy the correct flywheel it makes it that much easier
Follow Ups	Pic/ info request - Nis300owner 02:23:01 10/01/11 Re: Pic/ info request - Wright (Ca) 07:54:40 10/01/11 Re: Pic/ info request - ouikikazz 08:46:17 10/01/11 Sorry forget that info. I have the southbend - Nis300owner 13:11:59 10/01/11 Sometimes you only need the Ramey starter spacer - Joe@ZSpeedperformance 13:49:56 10/01/11
Post a Followup	You cannot reply to this message because you are not logged in.