Subject	Thoughts.
Posted by	Bernie (NoVA) on September 22, 2011 at 10:45 AM
	This message has been viewed 139 times.
In Reply To	96 TT Exhaust TP and O2 sensor question?... posted by SMAZ on September 22, 2011 at 10:30 AM
Message	I doubt they will reach. Do not cut the wires - they are stainless and are hard to crimp/extend. Make some jumper harness extensions if you can get a hold of the right male/female connectors. Rear 02s need to read less then the front O2s so you need some kind of spacer/restrictor on them otherwise the system will fault. Bernie Bilski berniebilski@cox.net 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red ZCCNV #390 ~ ECZA #368
Follow Ups	96 TT Exhaust TP and O2 sensor question?... - SMAZ 10:30:47 09/22/11 Thoughts. - Bernie (NoVA) 10:45:16 09/22/11 2nd. Had my 96 NA on the lift yesterday and I own a set - ConVerTT 11:16:36 09/22/11 I'm tempted to just leave the stock CATS and install the - SMAZ 12:21:41 09/22/11 My '96 has the hi flow cats installed by SZ. No smell :) (n/m) - sasha 14:12:24 09/22/11 I have a set of TPs wth high low cats and a set without ... - ConVerTT 14:30:25 09/22/11 I also have the SZ 3" Pipes with high flow cats - johnnysombrero 22:03:01 09/22/11 I have a set of SZ SS w/Hi-flow cats from my 96TT - BoneZ (MD) 14:55:02 09/22/11 SMAZ is the OP so I will let him go first ... - ConVerTT 14:59:10 09/22/11 Cool, Thx. Been sitting on these and the DP for a while now (n/m) - BoneZ (MD) 15:13:17 09/22/11 Sent you an email. - SMAZ 20:22:37 09/22/11 They probably wont reach....also, dont cut the wires... - RonZ300 (Socal) 15:24:44 09/22/11
Post a Followup	You cannot reply to this message because you are not logged in.