Subject	Specific paint needed for aluminum...
Posted by	Coldfusown on September 19, 2011 at 2:04 PM
	This message has been viewed 136 times.
Message	I have been reassembling my motor and painting the things as I go. Painted valve covers with no issue, timing belt covers, and I am painting the water pipes that come off the front of the motor, upper and lower. I know these are a material much like the plenum but the paint I am using, Engine enamel high temp and whatnot isn't sticking to the surface, rather running strangely. Can someone recommend a paint for this type of material?
Follow Ups	Specific paint needed for aluminum... - Coldfusown 14:04:13 09/19/11 Engine paint should stick fine - ZXoltan 14:33:42 09/19/11 I used engine enamel on mine, did you do any prep work or - JonnyZ(SoCal) 16:24:41 09/19/11 Good point - ZXoltan 16:47:52 09/19/11 I just scrubbed down in the sink with degreaser and then - Coldfusown 20:28:30 09/19/11 Bulldog or similiar adhesion promoter is also I good idea... - jzack 17:25:57 09/20/11
Post a Followup	You cannot reply to this message because you are not logged in.