Subject	Axle Spline question........is it necessary to put any type
Posted by	Arkham_Z on September 14, 2011 at 4:32 PM
	This message has been viewed 233 times.
Message	of lube, corrosion preventative, or anti-seize of any type on the splines before putting the axle back in the wheel bearing? There is nothing in the service manual but it seems like something should go in there so it doesn't rust together. I had to beat the hell out of one of them and almost destroy it to get it out because it was full of gunk and rust. I'm thinking at least a light coat of anti-seize. Any suggestions from the track guys/know all's??
Follow Ups	Axle Spline question........is it necessary to put any type - Arkham_Z 16:32:26 09/14/11 Antiseize and high temps are sometimes not a good idea. - Bernie (NoVA) 16:57:46 09/14/11 After having a hell of a time removing some of the - JMartz 06:46:46 09/15/11 I alway apply liberal anti-sieze to all exhaust bolts - Crim 09:40:44 09/15/11 What about some wheel bearing grease? (n/m) - Supermario680 (WI) 17:07:18 09/14/11 not necessary, but it doesn't hurt - aliaZ 17:30:46 09/14/11 Here you go - ttz'in (NorCal) 18:05:59 09/14/11 We use this stuff called molykote 77 at work - sandmanz32 18:38:30 09/14/11 The 350z's had the TSB as well. Molykote is good stuff. - nissanguyz32 07:26:35 09/15/11 True, it around 80.00 a can. I can get it free, so...... (n/m) - sandmanz32 19:50:39 09/15/11 Thanks all... (n/m) - Arkham_Z 20:31:02 09/14/11 yes, unless you want a headache later - FuerGrissa 13:16:08 09/16/11
Post a Followup	You cannot reply to this message because you are not logged in.