| Message |
NOTE: right off the bat I will tell you: the engine block bottom end was recently rebuilt after a rod knock issue, but the machine shop seems to have screwed the pooch on the rod bearing sizing and after barely 1000 miles, it has rod knock again. It's very much drivable, as the video shows, but the buyer will need to pull the engine and have the rods and rod bearings looked at. Engine has great compression, and the heads, and every single other part on the motor are all almost new. Rings are barely even broken in. I agree though, if you have the means, this car is a steal given everything installed on it...
|
 |