TwinTurbo.NET: Nissan 300ZX forum - Yup, just did one car and getting ready to do the next one.
Subject
Yup, just did one car and getting ready to do the next one.
Posted by
Milo (SATX)
on September 02, 2011 at 12:15 PM
This message has been viewed
99
times.
In Reply To
Well that sucked.....
posted by Madhatter10-6
on September 01, 2011 at 11:05 PM
Message
It sucks. No doubt about it.
Follow Ups
Well that sucked.....
-
Madhatter10-6
23:05:15 09/01/11
I did it twice.
-
huey24nissan(NC)
08:05:22 09/02/11
Why didn't you like them? Too rough? (n/m)
-
JMW300ZX
08:56:00 09/02/11
I too regret switching to ES bushings. They transmit too
-
Wright (Ca)
09:37:06 09/02/11
you're doing it backwards
-
LJZTT
08:54:20 09/03/11
I would have replaced the rear lower control arm bushings
-
LJZTT
08:51:09 09/03/11
drill bits, hole saw and air hammer is what I found
-
ZonaZ
10:21:19 09/02/11
and yes it does suck, good Z times... (n/m)
-
ZonaZ
10:23:50 09/02/11
IMHO too stiff of a ride, been there done that.. (n/m)
-
MidLifeZ (DFW)
10:32:38 09/02/11
Yup, just did one car and getting ready to do the next one. -
Milo (SATX)
12:15:52 09/02/11
BTW, burn em out. Hole saw for a lot of black crap left over
-
Milo (SATX)
12:17:37 09/02/11
I do the same, except no need to burn them out first. (n/m)
-
Woody75 (Denver)
12:32:53 09/02/11
Post a
Followup
You cannot reply to this message because you are not
logged in
.