Subject	After powdercoating
Posted by	MikeC(NZ) on August 23, 2011 at 5:30 AM
	This message has been viewed 111 times.
In Reply To	Yea . . . prob going to get rid of them. (n/m) posted by toykoz32 on August 23, 2011 at 12:06 AM
Message	I recommend machining off the powder coating on the inside of the wheels where they mate with the hub. If they get hot it can melt the powdercoating and cause the wheel nuts to loosen. Best to mask the inside of the wheels before powder coating - but I forgot too when i just had mine redone.
Follow Ups	Picked my wheels up today, and photos of the paint progress. - toykoz32 21:32:08 08/22/11 Did you test fit them? Clear BBK? Any fender issues? (n/m) - 300twinz (satx) 22:08:20 08/22/11 Im going with BBS LM's - toykoz32 22:13:03 08/22/11 been looking for a set the correct size myself (n/m) - LJZTT 07:23:30 08/23/11 off the BBS's? (n/m) - toykoz32 10:29:00 08/23/11 No problems with these - lidz 03:23:25 08/23/11 on that note - lidz 03:47:21 08/23/11 Suite! You gonna spray the same color as last? (n/m) - Ba11erz (MD) 22:09:11 08/22/11 ?!?!?! Painting the Z cyber Grey from the ZR1 (n/m) - toykoz32 22:14:09 08/22/11 Looking good so far! Keep it up. (n/m) - TheTwinZ (Peru) 22:32:36 08/22/11 Thinking about selling the Nismo LM's then? (n/m) - Ghoztt (CO) 00:05:36 08/23/11 Yea . . . prob going to get rid of them. (n/m) - toykoz32 00:06:39 08/23/11 After powdercoating - MikeC(NZ) 05:30:02 08/23/11 They have already be Pc'd, in the piture they are taped - toykoz32 10:27:52 08/23/11 Coming along, keep it up. (n/m) - Milo (SATX) 12:21:53 08/23/11 Wow, these wheels sold fast. (n/m) - toykoz32 22:08:40 08/23/11
Post a Followup	You cannot reply to this message because you are not logged in.