Subject	If your going to use WI, you really should tune for it
Posted by	Greg D. (Specialty-Z) on August 19, 2011 at 8:04 PM
	This message has been viewed 534 times.
In Reply To	no -- I only had water for 1 or 2 runs as I didn't posted by The Devils Z on August 19, 2011 at 07:31 PM
Message	and have a second program for the WI. The gains are significant if you tune for it. Just adding the WI with the same tune and boost level normally hurts power. That 21 PSI spike is dangerous and doing damage without WI on pump.
Follow Ups	Ztuner Dyno Day pics - more - The Devils Z 10:10:55 08/19/11 Quick comments - ztunerz 10:39:33 08/19/11 info: we both have 2.5 inch intercooler piping + massives - The Devils Z 11:05:35 08/19/11 I had to put my stock turbo inlets on! - BoneZ (MD) 11:24:27 08/19/11 ahh good info, that makes your quick soop even more amazing (n/m) - ztunerz 11:33:20 08/19/11 ..... kinda makes sense - The Devils Z 11:36:44 08/19/11 I dis-agree - Greg D. (Specialty-Z) 16:24:06 08/19/11 oh man is that green run nice (n/m) - zgene4 17:22:45 08/19/11 I think based on what you have said in the past and - The Devils Z 18:17:06 08/19/11 Incorrect ........ - Greg D. (Specialty-Z) 18:45:23 08/19/11 makes sense now ... when I first went to full 3 inch - The Devils Z 19:29:22 08/19/11 Agreed, times change......... - Greg D. (Specialty-Z) 19:58:07 08/19/11 upgrade your sig ! (n/m) - The Devils Z 11:37:31 08/19/11 So you moved? Glad you finally got tuned! (n/m) - BigTDogg (MA) 15:00:17 08/19/11 Yep! Finally got things to line up. (n/m) - BoneZ (MD) 18:32:54 08/19/11 link to images - ztunerz 11:19:26 08/19/11 thanks for this .. good read (n/m) - The Devils Z 11:48:11 08/19/11 My 25 cents on the charts - Greg D. (Specialty-Z) 15:05:43 08/19/11 hi Greg :) - ztunerz 16:07:46 08/19/11 Hey Harry - Greg D. (Specialty-Z) 16:58:53 08/19/11 so you support the use of h20 inj now huh :) - The Devils Z 18:02:39 08/19/11 No, I personally will not use it..... - Greg D. (Specialty-Z) 18:26:09 08/19/11 no -- I only had water for 1 or 2 runs as I didn't - The Devils Z 19:31:45 08/19/11 If your going to use WI, you really should tune for it - Greg D. (Specialty-Z) 20:04:13 08/19/11 Tune for WI. Some folks end up washing down their rings (n/m) - RevTech 23:15:18 08/19/11 I use it for safety / buffer ---not power --- - The Devils Z 15:36:25 08/20/11 The proper amount of water will cause the engine to run - Greg D. (Specialty-Z) 00:29:04 08/21/11 ur right -- but I have been running water - The Devils Z 11:56:08 08/21/11 Blacked-out tails FTL. (n/m) - Inzane 11:01:20 08/19/11 more quick comments - keefer vs tonyz vs ztuner - ztunerz 16:09:25 08/19/11 >>> - ztunerz 16:14:17 08/19/11 Do I have the colors mismatched to the cars, or am I seeing - LJZTT 17:42:09 08/19/11 You need to look at the whole chart ....... - Greg D. (Specialty-Z) 18:04:57 08/19/11 ok so the colors are listed in different order than names (n/m) - LJZTT 20:08:22 08/19/11 I can tell by looking at the charts that the green run - Greg D. (Specialty-Z) 20:43:09 08/19/11 Sorry i did not mark the names. It was a quick export to jpg - ztunerz 21:49:46 08/19/11 Didn't want 6 lines on one graph, too cluttered - ztunerz 21:51:55 08/19/11 I believe my run is the one in red. This was was a pump gas - phillyz 20:59:37 08/19/11 Ok then, need to redo my analysis then :) (n/m) - ztunerz 21:53:03 08/19/11 corrections with torque added and more resolution for boost (n/m) - ztunerz 23:17:45 08/19/11 What was the correction factor used on these dynos? (n/m) - Jeffblue 11:45:52 08/20/11 Some were 0 and some were 1% not huge (n/m) - ztunerz 20:29:49 08/20/11
Post a Followup	You cannot reply to this message because you are not logged in.