Subject	I would match mark them
Posted by	BlackholeZ on August 17, 2011 at 8:56 PM
	This message has been viewed 162 times.
In Reply To	Disassembling 2 piece wheels. posted by Evan(CA) on August 17, 2011 at 08:45 PM
Message	so that you get the same rim back with the same center, and clocked the same. Just to be safe. I would be surprised if they didn't have close tolerance bolts. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Disassembling 2 piece wheels. - Evan(CA) 20:45:23 08/17/11 Mark them so you put them back in the same position. - Joe@ZSpeedperformance 20:51:58 08/17/11 I've been looking for the torque specs but no luck yet. - Evan(CA) 20:56:34 08/17/11 They don't public the torque specs because - NytWolf 00:03:26 08/18/11 I would match mark them - BlackholeZ 20:56:07 08/17/11 As easy as it seems... - 90GoldZ 21:24:08 08/17/11 Mine... - 90GoldZ 21:33:37 08/17/11 I was only planning to do it so I could give them a good - Evan(CA) 21:45:06 08/17/11 Try contacting Rotiform - 90GoldZ 21:54:15 08/17/11
Post a Followup	You cannot reply to this message because you are not logged in.