TwinTurbo.NET: Nissan 300ZX forum - Yes, the concaveness depends on the wheel.
People Seeking Info
 
   


     
Subject Yes, the concaveness depends on the wheel.
     
Posted by PiotrC70 on August 11, 2011 at 10:50 AM
  This message has been viewed 202 times.
     
In Reply To Any idea of the offsets/wheel sizes he's running? posted by Jayru on August 11, 2011 at 10:01 AM
     
Message Take for example the Enkei PF01. Before deciding on my wheels, I really wanted these because they were lightweight and cheap. After much research, I found that the spokes stay pretty much the same position and the only thing that changes in the offset is the hat/lug area depth. Below isn't the best pic even though I've seen different angles.
[ http://blog.enkei.com/wp-content/Enkei_PF01_SEMA.jpg ]
[ http://www.blog.enkei.com/2010/10/27/2010-nissan-370z-nismo-with-enkei-pf01-%E2%80%93-see-it-at-sema-in-the-car-show-area/ ]
Look how shallow that front is compared to the rear.

Now look at my wheels from an old post. Offsets didn't change much even though the width did by 1" and the concaveness is very obvious. I can say that just by glancing at the fronts, I can probably fit 14" akebono's and still have breathing room.
[ http://www.twinturbo.net/nissan/300zx/forums/general/view/2422252/Oh-snap-look-what-just-arrived-BIG-GRIN.html ]

1993 TT. R.I.P. 09.15.2010
     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.