Subject	The trans mount desides the engine placement..
Posted by	91300zxttkid on August 09, 2011 at 10:15 AM
	This message has been viewed 156 times.
In Reply To	That works I guess. posted by Sleeper_TTZ(SeKy) on August 09, 2011 at 09:56 AM
Message	Basically it uses the bell houseing off a RB26 transmission mounted to the Z32 rear section.. Mounts in the stock location and i am using a one piece d/s the same one for a Z32. When making the engine mounts, You just tilt the engine slightly to get the shifter bracket to line up straight in the tunnel, and that's where it sits. I am looking for over 600hp on pump..
Follow Ups	RB Swap getting closer, also Slicktop swap,roofline delete - 91300zxttkid 08:32:48 08/09/11 How much space do you have from the front of the motor - Sleeper_TTZ(SeKy) 08:52:23 08/09/11 I will be making a v-mount setup or cutting out space to fit - 91300zxttkid 09:04:37 08/09/11 That works I guess. - Sleeper_TTZ(SeKy) 09:56:05 08/09/11 The trans mount desides the engine placement.. - 91300zxttkid 10:15:50 08/09/11 Re: RB Swap getting closer, also Slicktop swap,roofline delete - CmyZ 09:33:07 08/09/11 Car is for fun and drift, The motor is BUILT (n/m) - 91300zxttkid 10:16:36 08/09/11 RB parts a readily availible. - toykoz32 09:51:40 08/09/11 Some motor build pics... - 91300zxttkid 10:42:50 08/09/11 Full Supertech valvetrain minus valves - 91300zxttkid 10:46:22 08/09/11 Very cool. I hope mine is running by then too! - zfreak(Dallas) 18:10:52 08/09/11 I like it! (n/m) - 1badz32 (MN) 00:30:04 08/10/11 Its lookin good man (n/m) - Z32TT-R 13:51:11 08/10/11
Post a Followup	You cannot reply to this message because you are not logged in.