Subject	Improper tightening probably caused it.
Posted by	hunterg on July 29, 2011 at 9:09 PM
	This message has been viewed 103 times.
In Reply To	Any insight on preventing tail light cracks? posted by Buckaroo Banzai on July 29, 2011 at 08:26 PM
Message	Either you torqued them down too hard, or all were not equally torqued. Since the light has the tar insulation for a seal, not much torque is needed on the nuts.
Follow Ups	Any insight on preventing tail light cracks? - Buckaroo Banzai 20:26:24 07/29/11 Wash and wax? :) (n/m) - Drk93TT 20:59:37 07/29/11 Improper tightening probably caused it. - hunterg 21:09:35 07/29/11 Re: Improper tightening probably caused it. - Buckaroo Banzai 23:34:20 07/29/11 Might be user error considering you are DIY lens over - Gennosuke 21:37:32 07/29/11 Re: Might be user error considering you are DIY lens over - Buckaroo Banzai 23:39:34 07/29/11 You are pressing on them too hard when installing on car (n/m) - Bernie (NoVA) 00:11:31 07/30/11 indeed (n/m) - ttz'in (NorCal) 02:53:36 07/30/11
Post a Followup	You cannot reply to this message because you are not logged in.