Subject	New Stillen front bumper fitment has protruding edges at the
Posted by	TT-Z (Cape Coral, FL) on July 29, 2011 at 7:43 PM
	This message has been viewed 459 times.
Message	edge near the front tire well. Both sides have this protruding edge. The body shop says they aligned up the holes but could not get the front bumper to fit properly. Has anyone had this problem in the past? Is there a work around? The body shop says they can grind some of the edge off but that seems radical! Also, the previous Jspec bumper did not protrude like this one. :
Follow Ups	New Stillen front bumper fitment has protruding edges at the - TT-Z (Cape Coral, FL) 19:43:50 07/29/11 Re: New Stillen front bumper fitment has protruding edges at the (n/m) - 94ttz32 19:51:09 07/29/11 This is why test fitment & shaping is done before paint. - Bernie (NoVA) 19:56:44 07/29/11 Re: This is why test fitment & shaping is done before paint. - vg1134 20:07:50 07/29/11 Re: New Stillen front bumper fitment has protruding edges at the - CmyZ 21:01:24 07/29/11 doesn't appear to be much. may want to loosen the - ttz'in (NorCal) 03:02:04 07/30/11 That won't help 1 bit. The issue is the mold. (n/m) - Bernie (NoVA) 22:40:10 08/05/11
Post a Followup	You cannot reply to this message because you are not logged in.