Subject	Well i had a rear end clunk going on and pulled the reardiff
Posted by	fst300zx on July 16, 2011 at 12:08 AM
	This message has been viewed 200 times.
Message	anyone happen to have some tips on how to remove the output shafts of the Rear Diff? I have the yoke pulled I'm almost certain each output shaft has a snap ring closer to the center but cant figure out how to get to it or even see it? Has anyone else had to tear down the rear end. FSM doesn't show how to pull the input shafts. ">
Follow Ups	Well i had a rear end clunk going on and pulled the reardiff - fst300zx 00:08:27 07/16/11 Just pry them out - they pop in on a spring clip (n/m) - Bernie (NoVA) 07:39:38 07/16/11 sweet thanks i honestly thought they had a snap ring. (n/m) - fst300zx 10:12:54 07/16/11 slide hammer works great to remove and install (n/m) - ZonaZ 12:32:00 07/16/11
Post a Followup	You cannot reply to this message because you are not logged in.