Subject	And that is about the only decent reason I can think of
Posted by	BlackholeZ on July 14, 2011 at 3:44 PM
	This message has been viewed 203 times.
In Reply To	Labor to replace (if you use a shop) is $1000+ posted by dpjax on July 14, 2011 at 03:15 PM
Message	I'm throwing away a timing belt, tensioner, studs and idler pullies with only 30k on them because I can't use them again. Yeah, you don't want to have to pull your motor to swap rebuilt turbos every few years, but why do rebuilt turbos have to be so inferior to new ones? -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Rebuilt turbos=Bad idea? I don't get it - BlackholeZ 15:08:39 07/14/11 What happened? Turbo troubles already?? (n/m) - ZXoltan 15:11:57 07/14/11 no no no, just thinking ahead - BlackholeZ 15:31:41 07/14/11 cost effectiveness of doing the job properly perhaps? (n/m) - zgene4 15:13:06 07/14/11 Labor to replace (if you use a shop) is $1000+ - dpjax 15:15:38 07/14/11 And that is about the only decent reason I can think of - BlackholeZ 15:44:16 07/14/11 I was quoted over 3k once. - Draker (Eugene, OR) 17:10:18 07/14/11 Many that need rebuilds probably do have damaged wheels - hunterg 15:24:18 07/14/11 Re: Many that need rebuilds probably do have damaged wheels - supermario680 15:29:10 07/14/11 see, the smoking right after a rebuild I don't understand - BlackholeZ 15:36:32 07/14/11 Re: see, the smoking right after a rebuild I don't understand - supermario680 15:40:28 07/14/11 Exactly. - BlackholeZ 15:46:25 07/14/11 Mine aren't smoking bad, but it started about 7k miles after - hunterg 16:00:48 07/14/11 Also, mine aren't smoking under boost, rather it happens - hunterg 16:04:44 07/14/11 I'm going to guess. Metal subjected to stresses is not - zellamay 16:24:06 07/14/11 cost of new factory built and tested makes more sense. - Antihero 16:30:06 07/14/11 The center cartridge typically galls and distorts ....... - Greg D. (Specialty-Z) 17:28:13 07/14/11 That does make sense - BlackholeZ 17:37:21 07/14/11
Post a Followup	You cannot reply to this message because you are not logged in.