Subject	see, the smoking right after a rebuild I don't understand
Posted by	BlackholeZ on July 14, 2011 at 3:36 PM
	This message has been viewed 164 times.
In Reply To	Many that need rebuilds probably do have damaged wheels posted by hunterg on July 14, 2011 at 03:24 PM
Message	If done properly, there should be no difference in performance between a rebuilt turbo and a new one. If you rebuild an engine and have to resurface the crank (I know, not on our cranks) you spec a different bearing and have, operationally, the same thing. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Rebuilt turbos=Bad idea? I don't get it - BlackholeZ 15:08:39 07/14/11 What happened? Turbo troubles already?? (n/m) - ZXoltan 15:11:57 07/14/11 no no no, just thinking ahead - BlackholeZ 15:31:41 07/14/11 cost effectiveness of doing the job properly perhaps? (n/m) - zgene4 15:13:06 07/14/11 Labor to replace (if you use a shop) is $1000+ - dpjax 15:15:38 07/14/11 And that is about the only decent reason I can think of - BlackholeZ 15:44:16 07/14/11 I was quoted over 3k once. - Draker (Eugene, OR) 17:10:18 07/14/11 Many that need rebuilds probably do have damaged wheels - hunterg 15:24:18 07/14/11 Re: Many that need rebuilds probably do have damaged wheels - supermario680 15:29:10 07/14/11 see, the smoking right after a rebuild I don't understand - BlackholeZ 15:36:32 07/14/11 Re: see, the smoking right after a rebuild I don't understand - supermario680 15:40:28 07/14/11 Exactly. - BlackholeZ 15:46:25 07/14/11 Mine aren't smoking bad, but it started about 7k miles after - hunterg 16:00:48 07/14/11 Also, mine aren't smoking under boost, rather it happens - hunterg 16:04:44 07/14/11 I'm going to guess. Metal subjected to stresses is not - zellamay 16:24:06 07/14/11 cost of new factory built and tested makes more sense. - Antihero 16:30:06 07/14/11 The center cartridge typically galls and distorts ....... - Greg D. (Specialty-Z) 17:28:13 07/14/11 That does make sense - BlackholeZ 17:37:21 07/14/11
Post a Followup	You cannot reply to this message because you are not logged in.